Negotiable

                                            Description: 
Smart Pump Controller will automatically START the-water-pump as soon as the water level falls below the predetermined level and it will SWITCH OFF the-water-pump as soon as the tank is full. Smart Pump controller ensures no overflows or dry running of pump there by saves electricity and water. This device will show overhead_water_level, reservoir_water_level and Pump_status on its LCD display. 

Some extra feature makes this controller SMART.
Test_mode and regular_mode.
**During Test_mode the device continuously check the water level after 30 seconds. So it decrease installation time. 
**In Regular_mode the device continuously check the water level after 3 minute. So it Increase the life time of water sensors. 
**During failure or disconnect of overhead water sensor the device stop the pump after reach to avg_run : min (max run time) 
**The device also show real time signal from the tank, Total ON/OFF of PUMP, Last Running Time, Total Running time. 

Specification: 
Technical Information: 
1. Applicable for home/ office/ industry and more. 
2. Single phase 220v AC. 2200watt max load. 
3. Size :17cm X 12cm X 4cm, 300gram. 
4. Internal voltage : 5vDC, 12vDC and 220vAC 
5. Water sensor Voltage : 5v. 
6. ON/OFF switch for manual control. 
7. 16x2 LCD display. 
8. Five step water level display On LCD. 
9. Internal 30A Relay, N/O, N/C. 
10. Control by atmega8 Micro-controller. 

features and advantages: 
11. Fully automatic and Easy installation. 
12. Dual Tank monitoring (overhead + reservoir). 
13. Ensure no overflows or dry running. 
14. Max Run time limit facilities.(Max:255 minute) 
15. Total Run time Counting.(Max:25599 Hours) 
16. Number of total Start/Stop Count.(max:9999) 
17. Last Run time Show in minute and second. 
18. Sensors and cable status show. 
19. one year guarantee.                                    

Similar ads

---

More ads from sadikul

---